![]() I used CoolTerm for logging the data with a timestamp. Your problem is that you are still using examples for a controller that is different from the hardware you have. ![]() This is as far as I got with the code and I can toggle the led on the arduino via sending a 't' char, problem is my printf message is not showing on the terminal and I HAVE NO IDEA how to refresh the menu XO.Īnd I can't seem to figure out part two of the question any tips to guide me through this are much appreciated. Thing is: It worked yesterday for 6 hours with a 10 second delay(i stopped it manually) and then it worked from 11pm yesterday till 10:30am this morning with a 15 second delay, i didn’t stop it here though. But I the output in CoolTerm and Data Visualizer COM5(the serial and CDC port in my computer) were all empty. #include #include #include #define UBBR_VALUE 0圆8 void setupUSART ( void ) void printStringToUSART ( char * str ) char ReceivedByte int main ( void ) It was a pain to initially set up (needed to use something like CoolTerm to program it), but has worked fairly well for all my radios, in every operating system. The system should use interrupts and place the microcontroller in low-power "idle" mode whenever it can. I ended up using a UCBT232B Serial Bluetooth Adapter to control my NRD-535D. Can we have 74880 supported by the Arduino IDE. coolterm is a simple serial- port terminal application ( no terminal emulation) that is geared towards hobbyists and professionals with a need to exchange data with hardware connected to serial ports such as servo controllers, robotic kits, gps receivers, microcontrollers, etc. 74880 is fast enough for most comms, and I now use it as my standard rate. This should continue until the user sends an "ESC" key from coolterm which should bring you back to the menu. When the esp8266 boots the baud rate is 74880, if you do not have your terminal set to 74880 the meaningful information it sends out comes out as garbage. The menu should not refresh - just the current uptime displayed one line at a time each second. Option 2 will cause the board to start sending out it's current up-time (time since boot) every second on the UART. The menu should refresh each time option is selected. Option 1 allows you to toggle the LED on PB5 by sending a 't' character to your board from coolterm. Write a program that does the following: Displays a menu on the UART with two options. ![]() Hi all hope you're well I'm trying to answer this question:
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |